Hot water system thermostat: If you’re finding that the water that comes from your faucet isn’t quite as hot as it was in the past it could be due to a malfunction in the thermostat. A malfunctioning hot water system thermostat for your water heater can result in increased electricity costs because the heating mechanism is inefficient and runs continuously. Also, it reduces the life of the device. So be sure to inspect it when you notice the first signs of trouble!
Your water is too hot
The water heater you have has a temperature and pressure release valve. It is a safety device to ensure that the boiler is able to efficiently vent the gases that have built up in the event of a malfunction. Sometimes, the accumulation of sediment inside those valves with time leads them to become stuck or shut. This can result in excessive internal steam pressure which can lead to a burst of boiling water and steam scalding. If the valve is not open, your water might constantly get more and more hot when it is flowing across the pipe. A skilled repairman can help you figure this out.
There’s not enough hot Water
When you turn the circuit breaker prior to turning on your warm water tap, the electrical current is passed through two wires, and then completes the circuit that connects to the heater’s heating system. If the hot water system thermostat doesn’t sense that it’s not hot enough, then electricity will not flow through the wires and there will be no heat produced.
It takes too long to Reheat
If you turn on the hot shower but it doesn’t heat within a matter of seconds, it’s likely that the thermostat hasn’t been permitting electricity to flow through into the heater. Since there’s no heating that can be used, the water will take longer than usual to heat.
Repair Thermostat of a Water Heater
The thermostat controls the temperature of water inside a water heater. If you set the temperature to low, the water will begin cooling before being distributed to the faucet. Also, if you set the temperature too high you risk burning or scalding the temperature of water discharged by the faucet.
Here’s how you can repair a thermostat when you aren’t getting warm water:
- Find the thermostats that are lower and upper.
- Make sure both thermostats are powered by a supply.
- Reset the hot water system thermostat by pressing the reset button and determine if it will or doesn’t work.
- Replace the thermostat in the event that there is no electric power to the upper unit.
- If your system’s upper part is getting power, but you are not getting hot water, you should replace the heating element on top.
If the temperature of your water isn’t quite right you can alter the thermostat by yourself. Below are three simple steps to adhere to.
- Find the thermostat control.
The knob controls temperature and is connected to the source of heat, which is usually red and situated in the front, lower middle portion of the heater.
- Find The Small Black Line or Arrow over the Knob.
The setting is the place where temperature is set, and the setting could be identified as “warm” or “hot.” It can also be indicated with dark lines (120 °F)) or an white line (105-110 degrees Fahrenheit).).
- The temperature can be adjusted between 120 and 105 degrees Fahrenheit.
Conclusion
The water leaks that occur from heaters may cause destruction to walls and floors and also present a significant risk from electrocution to anyone who is in the close vicinity of the unit as it is powered on.
If you detect gas in the vicinity of the water heater, switch off all appliances associated with the appliance. If there’s an issue with your thermostat for your water heater, contact professional plumbers in your area to repair or replace it as quickly as possible.